Kahr Forum banner

1 - 20 of 21 Posts

·
Premium Member
Joined
·
8,218 Posts
I have read up on the 80% lowers. Think I'll wait, already passed on a $75 new plastic one.
 

·
Super Moderator
Joined
·
23,329 Posts
Thanks for sharing.........
 

·
Registered
Joined
·
19 Posts
Discussion Starter #4
Not a problem, I picked up a few AR lowers, and a 1911 lower. Figure for the cost, especially the ones that come with the jig to finish the work in an at home drill press, that it was worth a go.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #8
uh, why do they have 7x what they need in the way of funding? are the products actually being shipped, or not? Is a milling machine required to finish the lowers? what's with the lack of instructions? that part stinks, if they are STILL not sending/selling the instructions, long after they got the needed funding.
I'm getting the prototype sent to me to check out of the AR sometime this week since I was their first funder, the 10/22 he's going to tool up and do after the ar's. He wants some feedback before he starts full production. And add far as instructions, there are tons of them online, and on YouTube.
 

·
Premium Member
Joined
·
8,218 Posts
EP80BLACK-2.jpg polymer 80% just have to grind the white out.

Neat but it's higher than the polymer receiver I passed on
 

·
Super Moderator
Joined
·
23,329 Posts
Very cool.......
 

·
Super Moderator
Joined
·
23,329 Posts
Nice job...........
 
1 - 20 of 21 Posts
Top