Kahr Handgun Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
323 Posts
Discussion Starter · #1 · (Edited)
update photo



Above is my modified case base swaging set-up. (push thru die)

1) decap dirty brass w/universal decapper
2) stainless steel pin wash w/lemi-shine,dawn, & hot water
3) rinse w/hot water. It cuts soap off
4) lay on towel til next morning
5) run all brass thru above set-up

Ready for press now and all these steps let me find and throw away all the bad brass. Then the super 1050 really goes fast. It cuts out the aggrivation of loading on progressives.
 

·
Premium Member
Joined
·
8,218 Posts
Cool, you ream out. Bullet sizer?

When I first started loading pistol, I scrubbed out every case with a Scotchbrite pad.
 

·
Registered
Joined
·
323 Posts
Discussion Starter · #3 ·
no toney: ya buy below


Then you buy lee FDC factory crimp die for what ever caliber your doing. Take the plunger out. Thats it!

Notice: if your doing 9mm you have to order a makarov lee FCD (factory crimp die). The lee 9mm FCD is tapered. See, all your swaging is the lower base 1/4 inch of 9mm brass.
 
1 - 3 of 3 Posts
Top