Grip Sleeve for P380?

Pachmayr Slip On Grip #4

I use skateboard tape on all my guns - and it works well.

Although, I was going to try the Pachmyr grip - over that - to see if it feels even better (increased size).

I just got the Pachmayr #4 grip. It does not fit my P380 tightly.
I have tried numerous pratice draws from my Superfly pocket holster and the grip slides down about 3/8" below the bottom of the magazine. Anyone else have this problem? Any suggestions?

Try a layer of duct tape between the grip and the sleeve. It might add just enough to tighten things up. Duct tape is fantastic for so many things.

Rather than duct tape, I'd suggest a wrap of this and put the sleeve over it. No sticky residue like duct tape if you want to remove it. Also, you could just use it instead of the sleeve.

http://www.rescuetape.com/?gclid=CNuVoIT86KICFZFg2god0DaZqw

If you have an AutoZone nearby, they have it also.

http://www.autozone.com/autozone/accessories/Intertape-Polymer-Group-1-in-x-6-ft-automotive-Stretch-N-Seal-tape/_/N-257y?counter=12&filterByKeyWord=tape&fromString=search&itemIdentifier=529801_0_0_

Joistman said:

I just got the Pachmayr #4 grip. It does not fit my P380 tightly.
I have tried numerous pratice draws from my Superfly pocket holster and the grip slides down about 3/8" below the bottom of the magazine. Anyone else have this problem? Any suggestions?

Click to expand...

Put the Pachmayr over a little skateboard tape...

Try a piece of bicycle inner-tube. I saw this on YouTube. It worked great on my PM40. It takes a little work to get it cut just like you like it...but the tubes are cheap and you can get several out of each inner tube. I made a couple for friends of mine that carry PM9's and they loved them.

Welcome................

TALON Gun Grips for Kahr P380

These are the best choice out there.

My bad...I did not realize this thread was ancient ade!!!

The advice was good at least...

Use one on my LC9 Ruger..love it:fat:

The Hogue Handall Jr. works well on the P380. It has a slight palm swell also. The cost is about 10 bucks. Enjoy.

Oops. I see this is a 2010 thread.