[hodad]

Just puchased a CM9. Haven't run any rounds throught it yet, but excited about it as my new EDC replacing my SW99

 

[Toney]

Howdy and congrats!!! I really like mine.

 

[Toney]

Waiting on you review and range report!!!

 

[hodad]

@ Toney

One question. Actually a couple.

Have you found it very difficult to remove the slide stop? I am hoping it is like my SIG and gets easier with time and use.

and

I noticed that the rear of the polymer frame, where it meets the slide on the left side, protrudes slightly. In other words, it is not precidely flush with the slide. I haven't had a chance to compare it with other CM9's and was just wondering if yours has that same characteristic.

No big deal just curious.

 

[Toney]

The slide is a little hard to hold back to get the pin out.
I hook my thumb in the trigger gaurd and hook my index finger on the end of the slide.
Use you other hand to help line the marks up then hold on while pushing on the pin. I often use the end of a lighter to push with.


My slide lines up good.

 

[hodad]

Thanks Toney. I think it is just a matter of getting used to the take down. I have been using a screwdriver handle to tap the slide stop out. Hopefully, with time I will just be able to push it out like my SIG.

 

[warbird1]

It did on my PM9. They are great little guns.