Kahr Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I am having trouble getting the slide back on the gun. It seems the guide rod doesn't easily go into the hole at the muzzle and this stops the slide from going back far enough to put the pin in. Any body have an idea what I am doing wrong. I usually get it finally after lots of frustration?:mad:
 

·
Premium Member
Joined
·
8,218 Posts
IMG_20130529_142414.jpg Just got to hold your mouth right.
I hook my thumb in the trigger and use my index finger to push the slid back, might have to bump it a few times for the guide rod to start through. Then I use the other hand to align the marks
 

·
Super Moderator
Joined
·
23,330 Posts
That's one very good way to do it, or you can basically use the same grip Toney is showing at the back end of the gun. Push forward with thumb while pulling back with fingers.
ImageUploadedByTapatalk1369856738.656560.jpg
 

·
Registered
Joined
·
25 Posts
Are you sure that you have the spring turned the right way? The two ends are not the same, and I had the same problem when I had the spring turned around backwards.
 

·
Super Moderator
Joined
·
23,330 Posts
Are you sure that you have the spring turned the right way? The two ends are not the same, and I had the same problem when I had the spring turned around backwards.
Yeah I wasn't paying attention, and in a hurry a few months ago and put the spring in backwards, it jammed the slide and it was a you know what to free it up !!!! Never again....................
 
1 - 5 of 5 Posts
Top